Hardware
Complete guides for physical installation of Rinho equipment, including electrical diagrams, connection harnesses, and accessory configuration.
Before installing, verify equipment compatibility with the vehicle and ensure you follow the corresponding electrical safety standards.
Product Guides
Installation of the most compact equipment in the Rinho IoT family
→Installation of the equipment with the highest number of I/O
→Installation of the equipment with integrated audio
→Pinout and Connections
Pin diagrams and electrical connections for each equipment.
| Product | Pinout | I/O Connectors |
|---|---|---|
| Zero IoT | View pinout | Accessories |
| Spider IoT | View pinout | Accessories |
| Smart IoT | View pinout | Accessories |
Hardware Configuration
DIP switches, CAN bus, and termination configuration.
| Product | Hardware Guide |
|---|---|
| Spider IoT (HW v3.4 or lower) | Configuration |
| Spider IoT (HW v3.5 or higher) | Configuration |
| Smart IoT | Configuration |
SIM Cards and Antennas
Installation of SIM cards and GPS/GSM antennas.
| Product | Guide |
|---|---|
| Zero IoT | SIM and Antennas |
| Spider IoT | SIM and Antennas |
| Smart IoT | SIM and Antennas |
Compatible Accessories
Temperature Sensor (1-Wire)
Allows monitoring of ambient or refrigerated cargo temperature with DS18B20 sensor.
| Product | Connection Guide |
|---|---|
| Spider IoT | Sensor connection |
| Smart IoT | Sensor connection |
iButton Keys
1-Wire identification devices for access control and driver management.
| Product | Connection Guide |
|---|---|
| Spider IoT | iButton connection |
| Smart IoT | iButton connection |
CAN BUS
Interface for reading vehicle data (ECU, OBD-II).
| Product | Connection Guide |
|---|---|
| Spider IoT | CAN BUS connection |
| Smart IoT | CAN BUS connection |
Post-Installation Verification
Procedures to verify that installation was successful.
| Product | Verification Guide |
|---|---|
| Zero IoT | Verification |
| Spider IoT | Verification |
| Smart IoT | Verification |
Installation Recommendations
Equipment location: Install the equipment in a location protected from extreme heat, humidity, and excessive vibrations. Avoid placing it near the engine or exhaust system.
Electrical Considerations
| Aspect | Recommendation |
|---|---|
| Power Supply | Connect directly to battery with 3A fuse |
| Ground | Ensure good connection to vehicle chassis |
| Protection | Use corrugated tubing for cable harness |
| Ignition | Connect to +12V signal with ignition on |
See Also
- General Configuration - Initial configuration