🔧 Installation - Smart IoT
Complete guide for physical installation of the Smart IoT device.
⚠️ Before starting
🚨
Critical safety warnings:
⚡ Do not manipulate SIM cards
with the device powered on
🔌 Maximum 200mA per output
Use relay for higher loads
📡 TTL 3.3V serial port
Do not connect RS232 directly
🔥 3A fuse mandatory
on power supply line
📚 Installation guides
📋
Connector PinoutPin diagram and connections
🔧
Hardware (DIP Switch)CAN Bus configuration
🔗
Accessory Connectors1-Wire, CAN Bus and more
📶
SIM Cards and AntennasDual SIM configuration
✅
VerificationPost-installation tests
🚀 Quick steps
Connect power supply
Connect VCC (pin 10) and GND (pin 1/9) with 3A fuse in line.
Insert SIM Cards
Place primary SIM in Slot 0 and optionally backup in Slot 1.
Connect accessories
Connect 1-Wire sensors, CAN Bus or other peripherals as needed.
Verify operation
Run diagnostic commands to confirm installation.
Last updated